RL Vision Knowledge Base
Support questions and answers for software by RL Vision.
Note: This is an archived discussion. Any bug, problem or suggestion mentioned here is likely to have been fixed since it was written.
Subject: Re: Placement of the Data for Batch Replace and Presets
Date: Wed, 18 Jun 2008 22:39:26 +0200Hi,
In old versions it is located in the same folders as Flash Renamer is installed in. In new version you will find it here:
C:\Documents and Settings\All Users\Application Data\RL Vision\Flash Renamer
.. unless you have Vista. On Vista it is located here:
%userprofile%\AppData\Local\VirtualStore\RL Vision\Flash Renamer\
// Dan
*****@***** wrote:
> Hi,
> Some time ago, I was attempting to port my Batch Replace and Preset data
> from an older to an newer version. At that time I learned that the file
> locations had changed for these data but now can't remember where they are.
> My CPU was replaced this morning and I did not remember to save the data to
> another drive. Would please write me as to where the Batch Replace and
> Preset data resides so that I may tell our LAN Staff where to look for it?
>
> Thanks!
> Roxanne C.
> MTAIP DSPO
>
>
>
In old versions it is located in the same folders as Flash Renamer is installed in. In new version you will find it here:
C:\Documents and Settings\All Users\Application Data\RL Vision\Flash Renamer
.. unless you have Vista. On Vista it is located here:
%userprofile%\AppData\Local\VirtualStore\RL Vision\Flash Renamer\
// Dan
*****@***** wrote:
> Hi,
> Some time ago, I was attempting to port my Batch Replace and Preset data
> from an older to an newer version. At that time I learned that the file
> locations had changed for these data but now can't remember where they are.
> My CPU was replaced this morning and I did not remember to save the data to
> another drive. Would please write me as to where the Batch Replace and
> Preset data resides so that I may tell our LAN Staff where to look for it?
>
> Thanks!
> Roxanne C.
> MTAIP DSPO
>
>
>